Trade.Information

Product Name: P5 Drive 600 Volt

Product Description

Specifications and Features: - The GPD 506/P5 is designed specifically for applications where overload and starting torque requirements are well known. Common applications of this type include fans, centrifugal pumps, commercial laundry machines, grinders, buffers, low-viscosity mixers, centrifuges and saws. Constant torque and variable torque ratings. V/Hz Control Mode. Alpha/numeric operator...Full function LCD english language operator and keypad with easy-to-read 16 character two-line format display. Easy input and monitoring of operating parameters. Built-in PID control...Eliminates cost of external device. Full featured scalable PID feedback with display and an inverse signal function. Energy savings control...Automatic output voltage adjustment in response to actual motor loading. Real-time energy savings based on motor algorithms. Increases motor efficiency by several percent. Network Communications links to DeviceNet or ModBus RTU. Under torque detection...Alerts the operator to conditions such as loss of load or broken fan belts. Dual-bridge, 12-pulse rectification...By using a zig-zag input transformer with dual secondary, input current harmonic distortion factor can be reduced over 90%. Peformance Features Ratings: 2 to 200 HP (VT) at 600 VAC Overload capacity: VT 120% for 60 sec (180% peak) CT 150% for 60 sec (200% peak) Starting torque: 150% DC injection braking: ramp or coast to stop, adjustable, current limited Electronic reversing Adjustable accel/decel: 0.1 to 3600 sec (2 each) Controlled speed range: 40:1 Critical frequency rejection: 2 selectable, adjustable bands Drive efficiency: 96 to 98% Energy $aving control: improves motor efficiency Displacement power factor: 0.98 Output frequency: 0.1 to 400 Hz Frequency resolution: 0.01 Hz with digital reference, 0.06 Hz with analog reference Frequency regulation: 0.01% digital (-10 ° to 40 °C), 0.1% analog (15 ° to 35 °C) Torque boost: full range, auto Jog forward and reverse Power loss ride-thru: 2 sec Inertia ride-thru Selectable auto restart after momentary power loss Programmable auto restart (0 to 10 attempts) after resettable fault Slip Compensation Protective Features Current limited stall prevention Synchronized start into rotating motor via speed search DC bus CHARGE indicator Optically-Isolated controls Phase-to-phase / phase-to-neutral short circuit protection Ground fault protection Electronic motor overload Current and torque limit Fault circuit: overcurrent, overvoltage, and overtemperature Over torque protection Under torque protection Design Features 32-bit microprocessor logic Surface mount devices Carrier frequency: selectable to 15 kHz Keypad operator controls LCD display: English alpha/numeric sixteen character two lines 24 VDC control logic Programmable contacts, one form C and one NO Timer function: contact-initiated RS-232 communications port Volts/hertz ratio: Programmable custom V/Hz patterns Multi-speed settings: 6 available Remote speed reference: 0 to 10 VDC or 4 to 20 mA Setpoint (PID) control with inverse input and Sleep function Signal follower: bias and gain Analog monitor output: 0 to 10 VDC NEMA 1 enclosed or protected chassis UL, cUL and ce listed; IEC 146 MTBF: exceeds 28 years Service Conditions Ambient service temperature: -10°C to 40°C (104°F) NEMA 1, to 45°C (113°F) protected chassis Humidity: non-condensing to 95% Altitude: to 3300 ft; higher by derating Input voltage: +10%/-15%, 500 to 600 VAC Input frequency: 50/60 Hz ± 5% 3-phase, 3-wire, phase sequence insensitive